Just because I’m used to work with VIM: sudo apt-get install vim You can set the Raspi to boot into command line only now, we don’t need the GUI anymoreĪll the following instructions you can perform on the command line or better within an SSH client of you choice (ie. In “Add/Remove Software” search for “Apache” and install “Apache HTTP Server”. Within the graphical UI configure Wifi, IP, Hostname. See also /Seeed-Studio/Wio_Lin … filesystem When inserting the cable, make sure the blue side is faced to the Ethernet port, and the silver side is facing the HDMI port.Raspberry Pi 3: WIO Link Server installation into the filesystem Insert the Camera module ribbon cable by gently pulling up the edges of the camera module port’s plastic chip.If you’re using Raspberry Pi B, it is between the Ethernet port and the HDMI port. On the Raspberry Pi, locate the Camera module port between the audio port and the HDMI port.
Note: Make sure the Raspberry Pi is turned off. Let’s head over to set up the components. This Pi Camera module can attach to the Raspberry Pi’s CSI port using a 15-pin ribbon cable.įor further reading on the Pi Camera Module, do check the docs. The Raspberry Pi Board has CSI (Camera Serial Interface) interface used to attach the PiCamera module.
It’s used together with an infrared light source to take pictures in the dark.